.

Performance Value Benchmark!

     - this is $4.87 per foot in single roll order

              Check out Volume Order Discounts up to 20% of

Achieve high performance as your standard from our high performance and user friendly LED flexible strip light tape.

The Helios FLEX 24VDC LED Light Tape is perfect for all kinds of architectural, accent, cove, wall-washing and host of task lighting with a selection of color temperatures and benchmark lumen output. Two series are available, both powered by industry standard Samsung SMD chips. Your choice of 5 color temperatures of either the Samsung 3528 (FLEX Standard) or the 5050 series (FLEX Power), delivering a price performance per linear foot that is hard to beat!

Featuring 90 CRI rating for excellent light quality and the ability to run up to 33 linear feet (10 meters) on a single class 2 power source, the Helios FLEX 24VDC LED Light Tape is ideal for many commercial/industrial and residential applications.

*- Substitute with S or P for Standard or Power series (ex. HEFB-24V2700.S for Standard series in 2700K color temp)  Available in 5 METER spools

Input:                                24VDC Constant Voltage

Power Consumption/ft.:          3.7W

LED Chip Type:                   Samsung 5050 SMD

LEDChips/ft (30cm):           18

Pitch between LEDs:           16.67mm (.656 inch)

LED Chip Beam Angle:       120°

Dimmable:                       Yes

Mounting⁴:                      3M™55280 Adhesive

Field Cuttable:                 ~4 in.(100mm)

MaximumRun⁵:                  33ft.

Connections⁶:                   3 inch hard wire ends

Ambient Temp⁷:               - 4  to 122°F  (-20 ~ 50°C)

Operating Temp⁸:             - 4  to 176°F  (-20 ~ 80°C)

Environment⁹:                  Indoor/dry location  (IP20)

Packaging Spools:           5 Meter (16 Ft.) Reels in ESD zip bags

                15M and Custom Configurations Available

HELIOS 24V Flex POWER

1. Samsung 3528/5050SMD Chip binning ranges:(2700K90+CRI:2580-2725K),(3000K90+CRI: 2870-3045K),(3500K90+CRI:3465-3710K),(4000K 90+ CRI: 3725-4050), (5000K90+ CRI: 4745-5028K).

2. LED chips have a luminous flux range with a tolerance of +/- 5%.

3. Actual efficacy value is dependent to specified LED driver (power supply).  An estimated efficacy value can be calculated as follows: Lumen value divided by average power consumption per foot.

4. Ideal tape application temperature range is 70°F to 100°F (21°C to 38°C).  Initial tape application to surfaces at temperatures below5 0°F (10°C) is not recommended because the adhesive becomes too firm to adhere readily. However, once properly applied, low temperature holding is generally satisfactory.

5. Each maximum run requires a dedicated power feed from the driver. Do not extend beyond the recommended maximum run length.

6. Wire leads and accessories are not rated for in-wall installation unless otherwise noted. Attached wire leads and connections are field cut able.

7. Do not install product in an environment outside the listed ambient temperature.  Exceeding the maximum ambient temperature may damage LED chips,reduce the total lifecycle, lumen output, and/or adversely impact color consistency.

8. Operating temperature is measured according to the minimum and maximum ambient temperature environment.

9. Do not install in environment where LED chips are exposed to direct sunlight as damage to the phosphor will occur.

©2018 HELIOS Engineering Inc.   All rights reserved.  Subject to change without notice.